Opel C20NE Throttle Body Adapter for Rover MG Manifold – 55mm Intake Adapter

Opel C20NE Throttle Body Adapter for Rover MG Manifold – 55mm Intake Adapter

This throttle body adapter is designed to fit a 55 mm Opel C20NE throttle body to a Rover / MG intake manifold. It is a useful part for custom intake conversions, engine swaps, or throttle body upgrade projects where the Opel C20NE throttle body needs to be mounted to a compatible Rover or MG manifold.

This is a custom adapter part and should be installed by someone who understands intake fitting, throttle body alignment, gasket sealing, and engine bay clearance.

⭐ Features

Designed for 55 mm Opel C20NE throttle body

Adapts Opel C20NE throttle body to Rover / MG manifold

Useful for custom intake conversion projects

Suitable for engine swap or custom throttle body setups

Simple adapter design for clean mounting

Strong and rigid construction

Designed for automotive engine bay use

Good option for custom Rover, MG, or Opel-based builds

🔧 Fitment & Installation

Main compatibility:

Opel C20NE 55 mm throttle body

Rover / MG intake manifold applications

Application:

Throttle body adapter

Intake manifold conversion adapter

Important fitment note:

This adapter is intended for custom conversion use

Please compare your throttle body, manifold bolt pattern, gasket surface, and available clearance before ordering

Fitment may vary depending on manifold version, throttle body version, engine setup, and modifications

This is not a complete conversion kit

Throttle body, manifold, gasket, bolts, sensors, cables, clamps, and other hardware are not included unless specifically stated

Installation notes:

Test fit the adapter before final installation

Check throttle body alignment before tightening

Use a suitable gasket or sealant where required

Make sure the throttle plate opens freely and does not contact the adapter or manifold

Check for air leaks after installation

Installation should be carried out by someone who understands custom intake and throttle body fitting

🖨 Material & Print Quality

Printed in ASA only

Heat-resistant – suitable for engine bay use

Strong and rigid construction

Designed for custom automotive intake applications

This is a 3D-printed part. Minor layer lines or surface marks may be visible. Optional light sanding or painting is recommended for a perfect cosmetic finish.

📦 Included

1× Throttle Body Adapter

Printed adapter only

Attribution:

Original design by Łukasz Nowakowski.