Holden Rodeo TF 4ZE1 Pod Filter Adapter – 4 Inch Intake MAF Adapter

Holden Rodeo TF 4ZE1 Pod Filter Adapter – 4 Inch Intake MAF Adapter

Upgrade the intake setup on your Holden Rodeo with this pod filter adapter, designed to fit where the stock air intake connects to the MAF sensor tube. This adapter allows installation of a 4 inch / 101 mm pod filter while keeping the factory MAF sensor tube layout.

This part was designed and tested for a 1995 Holden Rodeo TF with the Isuzu 4ZE1 engine. Fitment with other Rodeo or Isuzu 4ZE1 applications may be possible, but is not guaranteed.

⭐ Features

Designed for Holden Rodeo TF with 4ZE1 engine

Adapts the factory MAF sensor tube to a 4 inch pod filter

Suitable for 101 mm pod filter inlet size

Designed to bolt where the original air intake connects

Allows custom pod filter intake setup

Two small auxiliary ports are included but blocked by default

Strong and rigid construction

Designed for engine bay use

🔧 Fitment & Installation

Main compatibility:

1995 Holden Rodeo TF

Isuzu 4ZE1 engine

Tested application:

Australian delivered Holden Rodeo with 4ZE1 engine

Possible but unconfirmed compatibility:

Other Holden Rodeo models from the same era using the 4ZE1 engine

Some Isuzu vehicles using the 4ZE1 engine

Possible Isuzu Trooper applications from the same era

Important fitment note:

This adapter was tested on a 1995 Holden Rodeo TF with 4ZE1 engine only

Fitment with other engines, years, or markets is not guaranteed

Please compare your MAF sensor tube, bolt pattern, and available engine bay space before ordering

This is not a complete intake kit

Pod filter, MAF sensor, clamps, hoses, screws, and other hardware are not included unless specifically stated

Filter compatibility:

Designed for a 4 inch / 101 mm pod filter

Example style: 4 inch pod filter with rubber neck

Sensor / port notes:

The two smaller ports on the adapter are blocked by default

These ports are intended as possible locations for an air intake temperature sensor and vacuum line if needed

Opening or modifying these ports is the responsibility of the installer

MAF mounting notes:

The adapter is designed to fit where the stock intake bolts to the MAF sensor tube

Original mounting screws may be used

Hole alignment may not be perfect on every vehicle, so minor fitting or adjustment may be required

Installation notes:

Remove the factory intake section as required

Test fit the adapter to the MAF sensor tube before final installation

Install the pod filter onto the 4 inch adapter side

Check all clamps and connections before starting the engine

Installation should be carried out by someone who understands intake fitting and engine bay clearance

🖨 Material & Print Quality

Printed in ASA only

Heat-resistant – suitable for engine bay use

Strong and rigid construction

Designed for custom automotive intake use

This is a 3D-printed part. Minor layer lines or surface marks may be visible. 

📦 Included

1× Pod Filter MAF Intake Adapter

Printed adapter only