Single DIN Radio Mounting Bracket & Fascia for Land Rover Discovery 1
Install a Single DIN aftermarket head unit in your Land Rover Discovery 1 with this mounting bracket and fascia assembly. The design combines a supporting cage, front and rear spacers, and a finishing fascia with DISCOVERY lettering.
The mounting arrangement positions the radio farther forward, providing additional clearance for compatible head units with an extending screen.
Design and features
-
Designed for the Land Rover Discovery 1 dashboard
-
Accommodates a compatible Single DIN head unit
-
Printed mounting cage with integrated fixing bracket
-
Separate front and rear spacer pieces
-
Finishing fascia with DISCOVERY lettering
-
Forward-positioned layout for additional screen clearance
-
3D-printed construction
Vehicle fitment
Designed for the Land Rover Discovery 1 radio mounting area shown in the photos.
Modification to the existing plastic surround may be required. The original installation was developed on a vehicle with damaged surrounding plastic, allowing access to the metal dashboard bracket used to secure the assembly.
Compare your existing surround and metal mounting points with the design before ordering.
Head unit compatibility
Designed around a Single DIN radio body. Check the head unit’s casing dimensions, rear connector clearance, and faceplate shape before installation.
The designer positioned the cage forward to allow a compatible extending 7-inch screen to open clear of the surrounding trim. Clearance depends on the screen mechanism and the installed radio position, so check its full movement during fitting.
Fascia sizes
The design has two fascia widths.
-
175mm — the narrower option, described by the designer as matching the head unit width.
-
190mm — the wider option, intended to cover more of the dashboard opening.
Both use the same mounting arrangement. These measurements refer to the fascia width.
Assembly and installation
The cage slides around the head unit. The front spacer, cage bracket, and rear spacer are then secured to the metal dashboard mounting bracket.
Choose screws that suit the existing metal bracket and provide sufficient engagement through the assembly. The designer used 5 × 60mm screws on the example installation.
The fascia presses into place, with suitable double-sided tape available for additional retention if needed. Check that the radio itself is secured against sliding forward within the cage before final assembly.
Surface finish
These components are manufactured using 3D printing. Layer lines and minor surface variations may be visible on the fascia, lettering, cage, and spacer surfaces.
Package contents
Attribution
@Pugwash_271054 · CC BY 4.0