Headlight Air Intake for Honda Civic EG 1992–1995 – 3-Inch Duct, Left / Right / Pair
Create a front-facing air feed for your Honda Civic EG with this shaped headlight intake. Designed for matching 1992–1995 headlight openings, it replaces the main headlight position with an inlet that channels air toward a nominal 3-inch duct connection.
The contoured outer frame follows the headlight outline, while the recessed opening gives the front end a distinctive motorsport appearance.
Choose your configuration
-
Left side — one left-side headlight intake
-
Right side — one right-side headlight intake
-
Pair — one left-side and one right-side intake
Left and right refer to the vehicle’s sides when seated inside and facing forward.
Design and features
-
Designed for Honda Civic EG 1992–1995 applications
-
Shaped to occupy the main headlight location
-
Open front inlet with a tapered internal passage
-
Nominal 3-inch air duct connection
-
Integrated mounting tabs
-
Available individually or as a matching pair
-
3D-printed construction
Vehicle compatibility
Designed for Honda Civic EG 1992–1995 front-end configurations matching the product photos.
Compare your original headlight shape, mounting points, and surrounding panels before ordering. Check body-style compatibility against the pictured part, particularly if your vehicle has replacement panels or a modified front end.
Duct connection
The source design specifies a 3-inch diameter, equivalent to approximately 76.2mm.
Check the actual connection dimensions against your chosen hose or ducting before assembly. Hose fit depends on its internal diameter and the mounting arrangement used.
The inlet provides a starting point for a custom air feed. Airflow to the filter or other components depends on the complete duct route and surrounding installation.
Installation
Remove the corresponding headlight assembly and test-fit the intake in its position. Check mounting-tab alignment and clearance behind the panel before securing it.
Custom fitting, sealing, or additional brackets may be required depending on your setup. Route and support any connected ducting so it places minimal strain on the intake.
Surface finish
This part is manufactured using 3D printing. Visible layer lines and minor surface variations may appear on the front surround, internal passage, edges, and mounting tabs. Additional surface preparation and painting can be carried out for a smoother cosmetic finish.
Package contents
-
Left option — 1 × left-side headlight intake
-
Right option — 1 × right-side headlight intake
-
Pair option — 2 × headlight intakes, one left and one right
Attribution
Andresssar · Commercial License