Ducktail Rear Spoiler for Mazda MX-5 Miata ND – Trunk Lip Spoiler
Give your Mazda MX-5 ND a distinctive rear profile with this ducktail spoiler. Designed to follow the rear edge of the trunk lid, its swept shape rises above the bodywork to create a pronounced lip across the back of the car.
The installation photos show the design fitted to an MX-5 RF, illustrating its shape against the rear lights, trunk, and quarter panels.
Design and features
-
Designed for the Mazda MX-5 / Miata ND
-
Ducktail profile with a raised trailing edge
-
Curved shape following the rear of the trunk lid
-
Broad center section with shaped outer ends
-
3D-printed construction
-
Suitable for a custom exterior styling project
Vehicle compatibility
Designed for the Mazda MX-5 / Miata ND, with an RF installation shown in the source photos.
Compare your trunk lid and intended mounting area with the photos before ordering. Check how the spoiler will sit if your vehicle already has a rear lip or other exterior accessories.
Construction and finishing
The original design is divided into four printable sections, with alignment dowels at the joints to help position the pieces during assembly.
The finished spoiler shown in the source photos was joined, filled, sanded, primed, and painted. Achieving a similar appearance requires preparation of the printed surfaces and section joints.
Fit and installation
Test-fit the complete spoiler against the trunk lid before final finishing and mounting. Check alignment across the center and both outer ends, along with clearance when opening the trunk.
The attachment method must suit the spoiler’s mounting surface and your vehicle. Have the fit and mounting arrangement assessed by an experienced installer before securing it.
Surface appearance
Visible layer lines, seams, and surface variations are characteristic of the printed components. The final cosmetic result depends on assembly, surface preparation, and the chosen finish.
Attribution
@SpookyNachos_1398403 · CC BY 4.0