High-Beam Headlight Air Duct for BMW E30 – Grille Inlet with 90mm Hose Connection
Create a front-facing air feed in your BMW E30’s inner headlight position with this grille-style intake duct. Designed to replace the high-beam lamp, it combines a circular opening with horizontal slats that complement the surrounding front grille.
A rear connection accommodates compatible 90mm ducting for routing air toward a custom intake or cooling setup.
Design and features
-
Designed for the BMW E30 high-beam headlight location
-
Circular inlet with integrated horizontal grille slats
-
Rear connection for compatible 90mm hose or ducting
-
Mounting arrangement based on the original headlight
-
Developed using 3D-scanned reference geometry
-
Left-side and right-side designs available
-
3D-printed construction
Vehicle compatibility
Designed for BMW E30 applications with the matching inner high-beam headlight mounting arrangement.
Compare the original lamp, mounting points, and surrounding grille with the product photos before ordering. Check available space behind the lamp for the rear connection and planned duct route.
Duct connection
The rear connection is specified for 90mm ducting, approximately 3.54 inches.
Check your hose’s internal diameter and the actual connection dimensions before assembly. Allow sufficient space for the hose bend and its securing clamp.
The inlet provides an entry point for airflow. Its effect depends on the duct route and the intake or cooling components connected to it.
Side selection
Left-side and right-side versions are available. Match the selected version to the high-beam position being replaced.
Left and right refer to the vehicle’s sides when seated inside and facing forward.
Installation
Remove the corresponding high-beam lamp and test-fit the duct using the original headlight mounting arrangement. Confirm alignment with the surrounding grille before securing it.
Connect suitable ducting at the rear and support the hose so its weight places minimal strain on the printed mounting points. Check clearance from nearby wiring and components.
Surface finish
This component is manufactured using 3D printing. Layer lines and minor surface variations may be visible on the grille slats, circular surround, rear connection, and mounting features.
Package contents
1 × high-beam replacement air duct in the selected side configuration.
Attribution
Auto_3DShop · Commercial License ACL-2026-001