Dual 52mm Gauge Mount for Nissan 300ZX Z31 1984–1989 – Digital Combination Gauge Conversion
Install two aftermarket 52mm gauges in the original digital combination gauge location of your Nissan 300ZX Z31. This conversion mount replaces the factory auxiliary gauge assembly in the center dashboard, keeping your chosen instruments together within the existing dash layout.
The shaped panel includes two circular gauge openings and mounting features designed to use the original assembly’s attachment points.
Design and features
-
Designed for the Nissan 300ZX Z31 digital combination gauge location
-
Two openings for compatible 52mm aftermarket gauges
-
Uses the original gauge assembly mounting points
-
Fits within the center dashboard arrangement shown in the photos
-
Allows a custom combination of monitoring instruments
-
3D-printed construction
Vehicle compatibility
Listed for Nissan 300ZX Z31 1984–1989 with the matching factory digital combination gauge assembly.
The designer tested the mount on a 1986 Nissan 300ZX and expects compatibility across the listed Z31 years. Compare your original gauge unit, surrounding trim, and attachment points before ordering.
Gauge compatibility
Designed for two nominal 52mm gauges, approximately 2.05 inches in body diameter.
Select the instruments appropriate to your setup, such as boost, air-fuel ratio, oil pressure, or oil temperature gauges. Check the gauge body depth, bezel size, retaining hardware, and rear connections against the available space.
Installation
Remove the original digital combination gauge assembly and test-fit the replacement mount at its attachment points. Fit and retain each aftermarket gauge according to its manufacturer’s instructions.
The designer reports installation on the tested vehicle using the original mounting arrangement without drilling or dashboard modification. Wiring changes are required for the selected gauges, with any necessary sensors and connections determined by the instruments used.
Check clearance behind both gauges before refitting the surrounding trim.
Surface finish
This mount is manufactured using 3D printing. Layer lines and minor surface variations may be visible around the gauge openings, panel faces, and mounting features. Please review the product photos for the expected printed appearance.
Package contents
1 × dual 52mm gauge conversion mount with two instrument openings.
Attribution
DannysCreations · CC BY-SA